If your Kitchen Tap is dripping where the spout meets the base of the tap then usually a new set of O Rings should fix this problem. Troubleshooting : I have fitted O Ring Kit and tap is still leaking ? This could be due to how the O Ring Kit is fitted, so please check again. […]Continue Reading →
Archive for How to….
Here below are examples of actual Valves in Taps to assist with Identification (or check) and some additional information to assist you in making the correct purchase. Remember, you can always return any unused parts or email us firstname.lastname@example.org for further advice / help. We are used to reviewing taps and parts and can quickly […]Continue Reading →
Valve & Vernier Insert Changing Procedure for the Perrin & Rowe Oberon Mixer Tap It should be an easy matter to change the Valve & Vernier Insert if you follow these simple instructions and refer to the diagram below. 1) Turn off water supplies to mixer tap. Place plug in waste to prevent loss of […]Continue Reading →
From Perrin and Rowe (Avillion / Triflow / Atriflo) It should be an easy matter to change the Valve & Vernier Insert if you follow these simple instructions from Perrin and Rowe (Avillion) and refer to the diagrams below. 1) Turn off water supplies to tap. Place plug in waste to prevent loss of small […]Continue Reading →
When your Tap was first produced the manufacturer used a valve which had 2 flat sides on the nut (SP3308 (aka 3308R). This Valve has been discontinued and the manufacturer now uses a very similar valve with a six sided nut, SP3794 (aka 3794R). The Hot and Cold Valve are not interchangeable: The Hot opens […]Continue Reading →