Archive for Perrin and Rowe Tap Spare Parts Guides
Valve & Vernier Insert Changing Procedure for Perrin & Rowe Lever Taps It should be an easy matter to change the Valve & Vernier Insert if you follow these simple instructions and refer to the diagrams below 1) Turn off water supplies to tap. Place plug in waste to prevent loss of small pieces. 2) […]
Continue Reading →Valve and Vernier Insert Changing Procedure for the Franke Olympus Triflow Tap. The Triflow version has red , blue and green coloured indicators on the handles. Please note that this is a different tap to the Franke Olympus Filterflow. If you have the Franke Olympus Filterflow Tap, then you will have the letters C, H […]
Continue Reading →This is a common issue and for the purposes of this blog post we are assuming that we have shipped your order correctly . Two lever tap (not a bridge tap) The hot valve for hot water feed (usually on the left) opens clockwise & the cold valve for the cold water feed (usually on […]
Continue Reading →If your Kitchen Tap is dripping where the spout meets the base of the tap then usually a new set of O Rings should fix this problem. Troubleshooting : I have fitted O Ring Kit and tap is still leaking ? This could be due to how the O Ring Kit is fitted, so please check again. […]
Continue Reading →Valve and Vernier Insert Changing Procedure for Changing Tripure Crystal Handles / Valves It should be an easy matter to change the Valve and Vernier Insert if you follow these simple instructions and refer to the diagram below. 1) Turn off the water supplies to the mixer tap. Place plug in to waste to prevent […]
Continue Reading →